Product Description
Quick Specs:
- 1018 steel bash bar
- 6061 aluminum stand
- Carbon fiber airfoil 69" wide
- 3 AOA positions (angle of attack)
- Tamper-resistant hardware is included
- Charcoal powder coat on stand and end plates
Features:
- Designed and made in Santa Fe Springs, California
- Wing stand and bash bar come powder coated to prevent corrosion
- The "angle of attack" can be adjusted by simply changing forward holes
- The foil height is set to be as efficient as possible, per its particular design and vehicle application
- Built-in "X" brace is designed to increase lateral & torsional strength, reducing side-to-side & twisting flex
- Professionally TIG welded for aesthetics and strength (vs.) using heavy bolts, washers, and nuts which induce stress on weak areas
- Chassis-mounted through our bash bar, which has been tested & proven to be strong & effective, so your rear end will be fully protected
- Easily height-adjustable through our anti-slip lower brackets. We don't use straight slots, because having the wing shift while driving is not beneficial
- Just bolt our bash bar onto the OEM location & you're good to go! No need to cut, drill, or weld anything onto the car! Exceptions may apply.
What's included:
- 1 set of tamper-proof hardware & tools
- 1 rear bash bar (jack point is optional at an additional cost)
- 1 set of light-weight aluminum end plates for road race functionality
- 1 aluminum wing stand (constructed to be strong & very light, weighing only 9.4 lbs. )
- 1 foil/wing deck (69" wide, made of carbon fiber for strength and light weight of 7.5 lbs)
Chassis Mount Wings FAQ
Can Street Faction make a chassis mount wing for my car?
- Due to high demand and limited time for R&D, they are no longer developing rear bash bars for non specified chassis mount wings for the time being.
- If you can have your own rear bash bar made, then they can sell our entire chassis mount kit to mount onto your rear bash bar. It comes with everything besides the rear bash bar. Street Faction will provide universal mounting brackets to weld onto your existing bash bar.
- Just bolt our bash bar onto the OEM location & you're good to go! No need to cut, drill, or weld anything onto the car! Exceptions may apply.
Can I still access my trunk?
- Yes, you can still access the trunk by removing the bottom most bolts & swinging the entire wing assembly back until it stops on the bash bar.
Can I still run my rear bumper?
- Yes, you can still run a rear bumper while retaining the functionality of the pivot feature, but you'd have to cut out two slots for the bumper to slide over the brackets.
Is the wing welded onto the bar?
- No, the wing assembly is not welded onto the bar. The mounting brackets are welded onto our bars, which allows the wings to bolt onto our bars.
What if I already have a rear bash bar but want to run your wing?
- You can purchase our wing setup without our rear bash bar! We can include two mounting brackets which would be needed to weld onto your existing rear bash bar. However, we can't guarantee functional deck height for bars that were not made by us, since the bar is not our design.
Disclaimer: This product was NOT designed to be used as a safety device. We do not recommend standing on our chassis mount wings. There is a possibility of the wing deck breaking if too much weight is applied which could cause injuries.
We don't manufacture the carbon fiber air foils, therefore we can not make any guarantees pertaining to the quality and lifespan of the air foil that you may receive. However, we do our best to source the best air foils possible.